NanoAAB 3rd Generation Active Breaking Mosfet GATE Electronics
This is the latest standard 3rd generation MOSFET. It uses the newest and up to date transistors and microprocessor for the smallest and most reliable MOSFET in it's class. Thanks to it's special coating it's resistant to water. It can work with all AEG replicas.
Maximum battery rated voltage - 12.8V
Better trigger reaction, higher rate of fire & power upgrades to your AEG are all excellent reasons to install a MOSFET.
It transfers the high current power from the battery directly to the motor bypassing the mechanical trigger contacts.
As a result not only are you acheiving all of the above but also you are protecting your trigger contacts from burning out and having to be replaced.
Would you like to increase the realism and the lifespan of your gearbox? Does your rifle has such a high rate of fire that it's double firing on single? Active breaking will sort all of that out for you!
In SEMI the active breaking will stop the piston in the forward position thus increasing the lifespan of your main spring which is especially important with stronger AEG's.
Once the trigger is released the active breaking will stop the gun immediately thus increasing realism and preserving your ammo which will come in handy especially when used with low to mid capacity magazines.
This MOSFET will not let you down on the battlefield.
It is fully protected against overheating and short-circuits of the eletrical system.
It will protect your motor and battery as well.
It is fully compatible with micro switches.
It enchances the rate of fire and trigger response and operates much cooler.
The use of modern transistors and microcontrollers offers the smallest and most reliable MOSFET's on the market.
- spare set of deans connectors
- single signal wire for trigger contacts
- dual signal wire for trigger contacts
- assorted heat shrink
12 months manufacturers warranty
Please note: this product requires fitting - any damage caused during installation will not be covered by the warranty.
Airsoft Zone is an official distriubtor of GATE products in UK and is delighted to offer a promotional fitting service on any GATE Mosfet purchased from us with an engineering fee of only £15.
For full details please follow this link
The technological process of GATE
Every product at GATE goes through an advanced technological process. Prototypes are designed using modern software and sophisticated hardware.
GATE's main goals are reliability and miniaturization. Prior to its introduction to the market each product is tested by a team of 50 independent beta-testers.
Thanks to GATE's long-term research, meticulous testing and extensive experience - GATE products are reliable and can operate under the most challenging conditions.
All products comply with ROHS 2 and meet CE standards.
Electronic circuits are made using modern technologies, SMD 0603 components and 9 mils wires as standard. High-density multi-layer PCB's allow for the miniaturization that GATE offers.
In high power circuits GATE uses most powerful transistors available on the market - 'HEXFET Power MOSFETs International Rectifier’. Thanks to the use of high quality components GATE products are reliable and able to work in harsh conditions.